A deadweight tester is a calibration standard that uses the principle of a pressure balance to calibrate pressure measuring instruments. Deadweight testers use calibrated weights to apply known pressures to a device under test for a simple and cost-effective solution that covers a wide range of pressure calibrations.

A gauge, in science and engineering, is a device used to make measurements or in order to display certain dimensional information. A wide variety of tools exist which serve such functions, ranging from simple pieces of material against which sizes can be measured to complex pieces of machinery.

Impact testing machines evaluate an object's capacity to withstand high-rate loading and it is commonly used to determine the service life of a part or material. Impact resistance can be among the most challenging qualities to measure. ... There are two standard kinds of impact test: Charpy and IZOD.

A compression test is a method for determining the behavior of materials under a compressive load. Compression tests are conducted by loading the test specimen between two plates, and then applying a force to the specimen by moving the crossheads together.

Glow wire testing is an example of the indirect flame method. Test results from applying these methods provide a way to compare the materials' tendency to resist ignition, self-extinguish flames (should ignition occur), and ability to not spread or propagate fire via dripping.

The Hot Set cable test is a straightforward means of determining if the material used in insulation or sheathing has been sufficiently cross-linked. A cross-linked material is one which has been altered to tighten and increase bonding between the polymer chains.

Bend test machines are typically universal testing machines specifically configured to evaluate material ductility, bend strength, fracture strength, and resistance to fracture. Bend tests tend to be associated with ductile metals and metal products.

We have utilized our expertise in collapse testing along with our advanced mechanical design and systems integration capabilities to develop a Tubular Collapse Testing System that complies with the latest version of API 5C3 requirements.

The Ball Pressure Test Apparatus is used to check the integrity of dielectric material with respect to resistance to elevated operating temperature. The ball pressure test is referred in IEC 60335, IEC 60695, IEC 60950, IEC 61010, IS 302, IS 1293, IS 3854, IS 2215, BS, UL, CSA and European norms.

A water bath is a laboratory equipment that is used to incubate samples at a constant temperature over a long period of time. Water bath is a preferred heat source for heating flammable chemicals instead of an open flame to prevent ignition.1

An incubator is a device used to grow and maintain microbiological cultures or cell cultures. The incubator maintains optimal temperature, humidity and other conditions such as the CO2 and oxygen content of the atmosphere inside.

A pendulum impact testing device, or a pendulum impact tester, is a contraption with a swaying pendulum that is released to produce impact on a secured specimen. The pendulum is fitted with a weighted hammer attached to its end, and hits the test specimen.